I apologize for not writing sooner. The last I wrote, it was 2Jun16, it is now 26Aug16. It has been awhile, and much has gone on here both in the world of Hyde as well as over there in the world of FrankenJeep.
So, what has gone on in the past few weeks?
Let us start out with the Extension Cord Escapades. I thought I was going to get a 6ga wire and use it as an extension cord. Well, let me tell you a little story about that.
It turns out that the 6ga was only two cord, I need at least three cord wire – hot, negative and ground. I might have been able to cut the 6ga wire in half, splice it and create a four cord, or simply use only one of those for a three cord wire, but then I am spending quite a bit of time creating a wire when I could have just spent a little more money and bought one.
I started looking on the line for a new extension cord: 600 Volt Cord
I found a 12ga extension cord that was three wire and 50′ long on the eBay for, well it was a bid war. They wanted $14.99 for processing and handling. Since I was not about to spend more than $100 to get this thing in my grubby paws, I put a max bid at $85.01 and waited. It was not too long before I got a message – “You have been outbid”
Oh well, on to the next thing. I kept searching, and I found a 10ga three cord, 50′ generator extension cord that came from the military surplus and it had a “buy it now” price of $50. After the processing and handling, plus the fees and whatnot, I think I paid right around $68 to have that cord in my hands. SCORE!!
Next, I had to rewire the j-box outside to accept this wire. We cut the female end of the wire off and connected it to the j-box, placing it on its own breaker and switch. Then we bought a new gang box to use on the end of the wire we just cut and wired that into a secure connection with its own plug outlets. Vi-ola! I have a new 50′ extension cord that will hold up to 600V. Now I can plug the welder into the extension cord, and it will not know that it is so far away from the supplied electricity.
Now I just need to fix my regulator gauges on the welder.